Detailed Product Description

Working principle:The damp raw material through conveyer and heated fresh air enter into the drierat the same time. They are mixed fully. Because the area of heat exchange is large,the purpose of evaporation and dry can be realized in a short time. The driedfinished product is discharged from cyclone separator. Small parts of powder dustcan be recovered and used through cyclone separator or bag duster.Model Q air stream is operated at negative pressure. The raw material does not passthrough fan. Model QG air stream drier is operated at positive pressure. Theraw material passes through fan with the effect of crushing. Model FG air streamdrier is tail air circle type. Model JG air stream drier is a reinforced type.It integrates flash dry and air stream dry into a whole, and is also the neweststyle of drier designed and manufactured by us.Features:1) The drying strength is large and investment of equipment is saving: the treating    amount of air stream drier is the largest. The evaporated moisture capacity of    equipment manufactured by us will be 50-150kg/h. Volume of equipment is small    and the investment is saving2) Automatic content is high, and the quality of product is good. Raw material to    be dried is inside the pipe, the drying time is short (0.5 - 2s), so that automation    can be realized. The raw material cannot contact with outer substances, so the     pollution is small, and the quality of product is good3) Equipment will be supplied completely and the heat source can be chosen freely:    air stream of drier will be supplied completely. The basic type consists of filter,    heater, feeder, drying pipe, fan and cyclone separator. Customer can install    duster and other auxiliary equipment in accordance with practical conditionsOn the choice of heating way, air stream drier has wide suitability. Customer canchoose steam, electricity and air-heated furnace to heat in accordance with practicalconditions. Meanwhile, it should be chosen in accordance with the temperatureof raw material to be resisted (or temperature of hot air): if ≤150oC,choose steam to heat; if ≤200oC, electric or steam and supplementalelectric or heat conduct oil; if ≤300oC, coal air-heatedfurnace; if ≤600oC, oil air-heated furnace should then be selected.